檢查刀削面機離心泵管路和結合處有沒有松動現象出現。用手轉動離心泵，看看離心泵是不是靈活。向軸承體內加入軸承潤滑機油，觀察油位是不是在油標的中心線處，潤滑油需要及時更換或補充。擰下離心泵泵體的引水螺塞，灌注引水。把出水管路的閘閥和出口壓力表及進口真空表關好。點動電機，看看電機轉向是不是正確的。開動電機，當離心泵正常運轉后，再把出口壓力表和進口真空泵打開看其顯示出適當壓力后，逐漸打開閘閥，同時檢查電機負荷情況。盡量控制離心泵的流量和揚程在標牌上注明的范圍內，可以確保離心泵在高效率點運轉，才能獲得大的節能效果。如發現離心泵有異常聲音要立即停車檢查原因(圖\文www.ingvk.cn/)。
中譯英：
Check the sliced noodles machine centrifugal pump and union department has no loose phenomenon. Hand rotating centrifugal pump centrifugal pump flexible have a look, is it right?. The bearing is added in the bearing lubricating oil, observe the level is it right? Standard in the oil of the center line, the need for timely replacement of lubricating oil. Unscrew the centrifugal pump body water plug, pouring water. The outlet pipeline valve and outlet pressure gauge and vacuum gauge shut. Move the motor, the motor is it right? Have a look to the right. The motor is started, when the centrifugal pump in normal operation, the outlet pressure gauge and vacuum pump to open the show proper pressure, gradually open the gate, at the same time to check the electrical load. Try to control the centrifugal pump flow and head in signs marked on the range, can ensure that the centrifugal pump at maximum efficiency point operation, in order to achieve maximum energy saving effect. Such as the discovery of centrifugal pump to stop and check the reason for abnormal sound.
|
